Dimmer Switch + Light Switch (Brass)

Yes – both options are supported. Trailing edge (default) is recommended for most LEDs, while leading edge may be better for some halogens or older LED bulbs.

Yes – you can set custom minimum and maximum brightness levels to avoid flicker and tailor dimming to your bulbs.

The dimmers are designed for high-quality dimmable LED bulbs or halogen lamps. Minimum load is 5W per lamp, with a total minimum of 5W per circuit.

No – Repenic are designed for UK homes and work without a neutral wire. This means they can be installed as a direct replacement for your existing wall switch in older properties as well as modern homes.

It should be at least 25mm.

In one circuit, there can only be one 2-way dimmer. If you want to control it from different locations, please connect it to 2-way or intermediate switches.

If you want to install multiple dimmers in the same circuit, please use our multi-way dimmers.

No need. Our brass plates have a protective coating on the surface that effectively prevents oxidation and fading, so almost no special daily care is required.

There is no limit on the number of lights controlled by the dimmer. As long as the total wattage of all lights controlled by this dimmer adds up to less than 250W. Due to certain errors in the nominal wattage of lights, we recommend that the total wattage of the lights be preferably below 230W.

Yes, but only if it meets the required safety standards and is placed in the right zone.

Click here to get more details.